Project book · an afternoon
Replace a kitchen faucet
Out with the drip, in with the new one. Most of the job is lying on your back under the sink.
This fits in a car
Shut it off first
How it goes · about an afternoon · some experience
- Empty the cabinet, shut off both valves under the sink, and open the faucet to let the pressure out and prove the water is off.
- Put the bucket under the valves, disconnect the old supply lines, and take a photo of how everything was hooked up.
- Undo the nuts holding the old faucet from underneath with the basin wrench, lift it out, and clean the sink deck.
- Set the new faucet in place following the instructions in its box, tighten it from below, and connect the supply lines to the same valves.
- Turn the valves back on slowly, run the water for a minute, and check every connection with a dry paper towel for a drip.
Something else